Removing Concrete Floor Anchors

Place the threaded nut onto the concrete anchor bolt.

Removing concrete floor anchors. Often a bolt can be removed simply by unscrewing it. Step 2 grip with pliers then grip the nut with pliers and pull upward. The more thorough the installation job the harder it will be to dislodge the anchor bolt from its position. Using a cutoff saw or grinding wheel cut the wedge anchor off at the surface of the concrete.

Before installing the wedge anchor drill the hole two times the length of the wedge anchor being installed. Step 3 use a bolt extractor on a stubborn bolt. Usually a screwdriver pipe wrench or vise grips can unthread the protruding bolt leaving the female anchor flush with the concrete. A steel anchor is stubborn and its removal will usually cause damage to the concrete floor.

To be removed wedge anchors can be sawed off with a hacksaw or cutoff wheel at the surface of the base material. Therefore don t be too hard on the anchor bolt when it refuses to budge. It s just doing its job. Remove the anchor bolt from the concrete by turning the bolt counterclockwise with the socket.

This video shows the process for removing the old unusable bolts and replacing them with new wedge anchor bolts in preparation for receiving a new delphi spe. The role of concrete anchor bolts consists of creating a permanent or at the very least semi permanent bond between the structure and concrete component. Protruding anchors may be removed using and angle grinder of a boltbreaker. Any protruding metal may be pounded into the concrete using a heavy hammer.

Some concrete anchors such as the tapcon concrete screws can be removed easily by turning them counterclockwise. If the bolt is rusted in place spray it with a penetrating lubricant and allow the lubricant to soak in according to manufacturer s instructions before removing. Female concrete anchors are generally simpler to remove. If the anchors are of the screw in type place a screwdriver bit into the drill position the bit into the head of the anchor and turn the fastener loose in a counterclockwise direction.

Tapcons are removable because they are threaded screws that tap threads into the concrete brick or block. There are only two ways to eliminate the wedge anchor from sticking above the concrete which are.