Revit Only Shows 2 Floors But The Building Has 3

Verify that the visibility of the object s category and subcategory are enabled.

Revit only shows 2 floors but the building has 3. This isn t an underlay nor is it a transparent floor. Given some walls that go from level 1 to level 2 and a floor at level 2 i have a project where these walls below show thru the floors in plan. Verify the detail level for the category of the element. Each level in your project must have a unique name.

Just for future reference when placing walls revit will default the base constraint to the level of the view you are in. The top offset will default to the last used value e g. Use the blue grip dot to drag the level head to the desired position. You can select the mass in any type of project view including floor plan rcp elevation section and 3d views.

Mass floors are based on levels defined in the project. Model categories can have detail level set independent of the view s detail level. See override graphic display of element categories. By default revit will name these new levels level 1 level 2 level 3 and so on.

A level s name helps you to identify what that datum represents be it a floor level underside of steelwork etc etc. Which suggests perhaps a setting somewhere. In addition to creating a level for each story in a building you can also create reference levels such as sill level. In the visibility graphic overrides dialog try the following.

If you are in the level 3 plan view then the base constraint will be set to level 3. On the ribbon click level. Click modify mass tabmodel panel mass. Create a scope box and apply it to the view.

If i start a new project from the revit template i don t get this behavior. After creating a mass for a conceptual design create a mass floor at each level defined in the project. Display a specific set of levels in the view and control their boundaries. Open the section or elevation view to add levels to.

For name enter 00 foundation and click ok. As you place the cursor to create a level if the cursor aligns to an. If you have not already done so add levels to the project. In the project browser under floor plans right click level 2 and click rename.

If you are in a level 1 view and set the top offset to level 2 the next. That sounds like a nasty little endless loop. Alternatively you can rename levels by renaming the corresponding view in the project browser. Architecture tabdatum panel level structure tabdatum panel level place the cursor in the drawing area and click.