Roof To Brick Wall Connection

The direct bearing connection is the simplest and most common connection in the home building industry.

Roof to brick wall connection. Most simply use a nominal 6 piece of lumber. A direct bearing connection is used in instances where the wall below does not continue beyond the roof level i e no parapet. Because most roof flashing is required to extend up the wall a minimum of 4 and some a minimum of 5. Pocket connection a pocket connection consists of framing the floor or roof system into a void in the masonry wall.

The most common roof to wall intersections involve either a gable roof with its ridge running perpendicular. A ledger board is a horizontal member that supports the ends of joists or rafters where they meet a. Flashing the connection where a shingled roof and a brick wall meet is complicated. It is also used when the wall below provides a ledge with sufficient bearing area for the roof to bear on directly.

How to frame a roof against a brick wall roof types. A ledger is a horizontal board that is attached to the top of the the wall. It takes coordination between the masons and roofers and it requires lots of custom fabricated metal flashing with soldered joints. This detail is used when masonry continues above either as part of the wall or as a parapet the connection location and eccentricity is to be minimized.